Step by Step Procedure To Add a Swap File Under Linux

In Linux, as in most other Unix-like operating systems, it is common to use a whole partition of a hard disk for swapping. However, with the 2.6 Linux kernel, swap files are just as fast as swap partitions, although I recommends using a swap partition. The administrative flexibility of swap files outweighs that of partitions; since modern high capacity hard drives can remap physical sectors, no partition is guaranteed to be contiguous. You can add swap file as a dedicated partition or use following instructions to create a swap file.

Procedure To Add a Swap File Under Linux

You need to use the dd command to create swap file. The mkswap command is used to set up a Linux swap area on a device or in a file.

Step #1: Login as the root User

Open a terminal window (select Applications > Accessories > Terminal) or login to remote server using the ssh client.  Switch to the root user by typing su - and entering the root password, when prompted

Step #2: Create Storage File

Type the following command to create 512MB swap file (1024 * 512MB = 524288 block size):
# dd if=/dev/zero of=/swapfile1 bs=1024 count=524288
Where,

1. if=/dev/zero : Read from /dev/zero file. /dev/zero is a special file in that provides as many null characters to build storage file called /swapfile1.
2. of=/swapfile1 : Read from /dev/zero write stoage file to /swapfile1.
3. bs=1024 : Read and write 1024 BYTES bytes at a time.
4. count=524288 : Copy only 523288 BLOCKS input blocks.

Step #3: Set Up a Linux Swap Area

Type the following command to set up a Linux swap area in a file:

# mkswap /swapfile1

Setup correct file permission for security reasons, enter:

# chown root:root /swapfile1
# chmod 0600 /swapfile1

A world-readable swap file is a huge local vulnerability. The above command make sure only root user can read/write to the file. Finally, activate /swapfile1 swap space immediately, enter:

# swapon /swapfile1

To activate /swapfile1 after Linux system reboot, add entry to /etc/fstab file. Open this file using a text editor such as vi:

# vi /etc/fstab

Append the following line:

/swapfile1 swap swap defaults 0 0

Save and close the file. Next time Linux comes up after reboot, it enables the new swap file for you automatically.

How do I Verify Swap is Activated or Not?

Simply use the free command to Check swap size Changes. 

$ free -m

Regards,

Vijay.